一次性紙餐盒是指制作所述紙飯盒所用的材料為紙材料的餐盒，一般為一次性紙飯盒，其使用方便，成本低廉，已廣泛運用于餐飲行業中。由于采用紙材料制作，因而既可以回收使用，又可以通過掩埋或燃燒等方式處理，而不致于造成嚴重的環境污染，具有較高的環保價值。

A disposable paper lunch box refers to a lunch box made of paper material, which is generally a disposable paper lunch box. It is easy to use and has low cost, and has been widely used in the catering industry. Due to the use of paper materials, it can be recycled and treated through burial or combustion, without causing serious environmental pollution, and has high environmental value.

紙餐盒的包裝運輸貯存：

Packaging, transportation, and storage of paper lunch boxes:

餐盒紙板和紙餐盒的包裝及標志按GB/T10342進行，通常應有內、外兩層包裝，包裝應整潔，數量應準確，或按訂貨合同的要求進行。

The packaging and labeling of cardboard and paper lunch boxes should be in accordance with GB/T10342, usually consisting of two layers of packaging: inner and outer. The packaging should be clean and the quantity should be accurate, or according to the requirements of the order contract.

內包裝材料必須清潔、無毒、無異味，并具有防塵、防水效能，包裝箱內應附有說明性標簽，并注明以下內容：

The inner packaging materials must be clean, non-toxic, odorless, and have dustproof and waterproof properties. The packaging box should be accompanied by explanatory labels and indicate the following:

a)產品名稱、種類、注冊商標、生產許可證及衛生許可證編號；

a) Product name, type, registered trademark, production license and hygiene license number;

b)生產廠名、產地、批號或生產日期、有效期；

b) Manufacturer's name, place of origin, batch number or production date, expiration date;

c)檢驗合格標記及標準代號。

c) Inspection qualification mark and standard code.

餐盒紙板和紙餐盒應妥善保管，以防止雨、雪和地面潮氣的影響。

The cardboard and paper lunch boxes should be properly stored to prevent the impact of rain, snow, and moisture on the ground.

有關單位在運輸和貯存過程中，嚴防有毒藥品和重金屬粉塵的污染。

Relevant units shall strictly prevent the pollution of toxic drugs and heavy metal dust during transportation and storage.

未經啟封的批量產品，其存放保質期應不超過1年。超期產品應按(3.2)的要求重新進行檢驗，符合標準的方可使用。

The shelf life of unopened bulk products should not exceed 1 year. Overdue products should be re inspected according to the requirements of (3.2), and only those that meet the standards can be used.

紙餐盒使用性能的測定方法：

Method for measuring the performance of paper lunch boxes:

A1容積測定

A1 volume measurement

在常溫下用1000mL的量筒，量取相應體積的水倒入紙餐盒中，大號餐盒600mL、中號餐盒500mL、小號餐盒400mL，目測應無水溢出即為合格。

At room temperature, use a 1000mL measuring cylinder to measure the corresponding volume of water and pour it into a paper lunch box. The large lunch box should have 600mL, the medium lunch box should have 500mL, and the small lunch box should have 400mL. If there is no water overflow, it is considered qualified.

A2耐水試驗

A2 water resistance test

將紙餐盒平放在紙板(或漿板)上，倒入溫度(90±5)℃、濃度約5%的NaCl水，再加甲基紅指示液1～2滴，高度不應低于20mm。1h后將水倒出，觀察背面、兩側是否有滲漏痕跡，若沒有發現滲漏痕跡即為合格，反之判為不合格。

Place the paper lunch box flat on the cardboard (or pulp board), pour in NaCl water with a temperature of (90 ± 5) ℃ and a concentration of about 5%, and then add 1-2 drops of methyl red indicator solution. The height should not be less than 20mm. After 1 hour, pour out the water and observe if there are any signs of leakage on the back and both sides. If no signs of leakage are found, it is considered qualified, otherwise it is deemed unqualified.

A3耐油試驗

A3 oil resistance test

將(150±10)℃的食用油(花生油、豆油)，用瓷匙加(10±2)mL于紙餐盒中，再將紙餐盒放在一張餐巾紙上。1h后觀察餐巾紙上是否有油點，如無油點則為合格，反之為不合格。

Add (10 ± 2) mL of edible oil (peanut oil, soybean oil) at (150 ± 10) ℃ to a paper lunch box with a porcelain spoon, and then place the paper lunch box on a napkin. After 1 hour, observe if there are oil spots on the napkin. If there are no oil spots, it is considered qualified, and vice versa, it is considered unqualified.

A4負重性能試驗

A4 load-bearing performance test

將紙餐盒平放在平板上蓋好盒蓋，用金屬尺測量紙餐盒的高度(連蓋)，精確至1mm。然后倒入漿砂混合物。蓋好盒蓋后，在上面放一塊200mm′200mm′3mm的平板玻璃。再將3kg砝碼置于平板玻璃中央，負重15s時立即取下砝碼及玻璃板，再精確測量上述高度。用下式計算試樣的負重性能值：

Place the paper lunch box flat on a flat plate and cover the lid. Use a metal ruler to measure the height of the paper lunch box (with the lid connected) to the nearest 1mm. Then pour in the slurry sand mixture. After covering the box lid, place a 200mm '200mm' 3mm flat glass on top. Place a 3kg weight in the center of the flat glass, and immediately remove the weight and glass plate when the load is 15 seconds, and then accurately measure the above height. Calculate the load-bearing performance value of the sample using the following equation:

式中：W試樣負重性能值，%；H0試樣高度，mm。H試樣負重后的高度，mm。

In the formula: W sample's load-bearing performance value,%; H0 specimen height, mm. The height of the H sample after being loaded, mm.

注：對于各種型號紙餐盒所用的漿砂混合物具體如下：

Note: For various types of paper lunch boxes, the specific slurry and sand mixtures used are as follows:

大號餐盒(600mL)：250mL水、50g紙漿及200g砂子；

Large lunch box (600mL): 250mL of water, 50g of pulp, and 200g of sand;

中號餐盒(500mL)：200mL水、40g紙漿及160g砂子；

Medium size lunch box (500mL): 200mL of water, 40g of pulp, and 160g of sand;

小號餐盒(400mL)：150mL水、30g紙漿及120g砂子。

Small lunch box (400mL): 150mL of water, 30g of pulp, and 120g of sand.

A5盒蓋折次試驗

A5 box cover folding test

將試樣盒蓋連續180°角開合15次，觀察與盒體連結處應無裂口、開裂。

Open and close the sample box cover at a continuous 180 ° angle for 15 times, and observe that there should be no cracks or cracks at the connection with the box body.

一次性紙餐盒的包裝運輸貯存及性能測定相關事項就講解到這里了，希望能夠?qū)δ兴鶐椭?，更多事?xiàng)就來我們網站http://www.ibluekiss.cn進行咨詢了解吧！

That's all for the packaging, transportation, storage, and performance testing of disposable paper lunch boxes. We hope it can be helpful to you. For more information, please visit our website http://www.ibluekiss.cn Consult and learn more!